![]() Make sure the pins are all aligned up correctly, and push together.Īttach foam pad and you are ready to close up the iPod.Īfter restoring and syncing – enjoy your iFlash’d iPod. The iFlash-Quad is a board, part of the iFlash lineup designed by Tarkan, which allows for four microSD cards to be inserted in place of the 1. Install the 4th Gen convertor to the iFlash board, making sure it is fully home and the locking bar is locked.Ĭarefully insert the 4th Gen connector to the iPod HDD ribbon. 127Gb 6g Bootloader emCore iFlash-Dual iFlash-Quad iFlash-Solo ipod classic LBA28 Rockbox SDXC Read more. The 4th Gen Convertor needs to be prepared for use, by creasing along the dashed lines.Ĭrease the 4th gen convertor ribbon along the dashed lines, as shown. IPod should be ready to install the iFlash board and converter. Do not put too much stress on the HDD connector. Pry and release the headphone/hold switch connection.Ĭarefully remove the HDD from the HDD connector. I recently started having problems with my iflash Quad iPod, here are the specs: iPod (80GB model MA450LL) 3000maH Battery Songs: 9771 Capacity: 953GB Available: 703GB Version: 1.3. Should work with majority of the Toshiba 44pin IDE hard drive using music players and devicesĬarefully pry open the iPod using suitable tools. Non-iPod Models Known to work reported by other users (please note we do not official support these, so you are on your own!). Model Identifiers on case back: A1099, A1059, A1040 This product is the converter only, you will also require a suitable iFlash adapter – iFlash-Solo / iFlash-Dual or iFlash-Quad is recommended.Ĭard compatibility will be similar but this not guaranteed until we have received users reports. Cards will work installed one at a time, but more than one causes RED X.For use on iPod 4th Gen Color/Photo/Grey Scale/BW and 3rd Generation models. ![]() Reports of Sandisk cards causing RED X when more than one used in the iFlash-Quad. 1-16 of 40 results for 'iflash quad' RESULTS iFlash Quad, Quad MicroSD Adapter for the iPod Conversion Adapter Genuine 3.0 (2) iFlash Quad MicroSD Adapter iPod 5G 6G 7G Video Classic Upto 4x Micro SD Cards 4.5 (165) Angelbird AV PRO CF- CFast 2.0 1 TB 4.2 (33) 49999699. And probably best to do it the thorough way before putting it in, just in case. MicroSD (SDXC) cards reported by iFlash users : Manufacturer / Brand And do i just put it in or switch formats (exfaf, fat32, etc.) G65434-2II Classic 5.5th (modded, 352GB), Classic 6th (2nd rev.) 3 yr. Be wary of cheap, high capacity cards – If it looks too good to be true – then it is fake! We always suggest testing the SD card fully using something like H2Testw.įullsize SD (SDXC) cards reported by iFlash users : Manufacturer / Brand Tip: MicroSD market is full of fake and mislabelled cards – try to purchase cards which the seller has obtained directly from the manufacturer. We suggest buying the fastest card in your budget as they tend to have faster access times and better quality memory chips. User Reported working SD cards (updated: 15th July 2023)Īll modern UHS-I U1 and U3 cards will generally work ok. IPod is now ready to restore & sync using iTunes. Slide battery cable in to the connector and push down the black latch to lock the ribbon in place. The iFlash boards will occasionally arrive DOA. Once the foam has been attached, the iPod is ready to be closed up. Attach 2nd Foam on top of 1st foam if installing in to a thick back iPod. Use 1 piece of foam for thin case back iPods. Place foam pad on the marked section on board. Install iFlash-Dual into iPod, making sure the ribbon is fully home and the black bar is locked down. Install SD cards in to iFlash-Dual – use socket SD1 if installing only 1 SD card. iPod is ready to accept the iFlash board. When everything arrived, I plugged the iPod into my MBP 14 with. Remove all rubber bumpers and strips from the iPods if any remain after the HDD is removed. Background: I had an old, very good cosmetic condition 5.5 Gen classic laying around that didn’t charge or turn on properly, so I went to EOE and ordered the tools, iFlash Quad card with 4 micro SD 64GB cards, and a 3000 thin battery. Gently lift the black bar to release the ribbon from the HDD. Rest the front and back side by side, be careful to not cause too much stress on the headphone ribbon. I suggest watching some iPod opening videos on the internet.īefore pulling the case apart, release the battery cable – lift the black lock bar -or- gently using even pressure pull up the battery ribbon away from the connector. Using suitable tools, release the holding clips, making your way around the case till it opens.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |